Installation & Assembly
Tools Needed
You will need a Pencil, Phillips head screwdriver, Tape
measure, Drill, Assorted Drill bits (5/16” & 3/8”), 16mm Wrench,
17mm Wrench, Squaring tool, 4ft Level, Rubber mallet and
Safety glasses. A large sturdy workbench or saw horses. Due
to the weight of the glass door, 2 people are recommended
for any lifting.
Parts List
Make sure ALL parts are included before beginning.
Glass Door & Track Installation
Fig. 6
Fig. 7
1-1/2”
4-1/2”
2”
2”
17.75
INCH
17.75
INCH
17.75
INCH
17.75
INCH
3
INCH
H +
2-3/8
INCH
with a
Max
height of
Height
plus 3-3/8
INCH
2. Determine Track
Location
On the same side where you made
your Height mark, measure 3” over
from the doorjamb and draw a line
so the 2 measurements intersect.
This will be the location of the rst
hole in the track. See Figure #1.
3. Insert Mounting Anchors and Install Track
Place the rst hole of the track at this intersection and using
the drill insert the proper anchors for your wall type. Make
sure the track is level while marking the remaining holes in
the track. Insert the remaining anchors and secure the track
to the wall using the screws provided.
Refer to Figures 1 & 2.
Fig. 1
2 Ea.
2 Ea.
1 Ea.
2 Ea.
5 Ea.
1 Ea.
2 Ea.
2 Ea.
1 Ea.
1 Ea.
1 Ea.
1. Measure for Track Height
In order to determine the proper Height for your Barn Door
Track, add 2-3/8” to the height of the door being installed.
Locate and mark this height on the wall (or mounting board)
on the side of the door jamb where the door would be in the
closed position. See Figure #1.
1 Ea.
5 Ea.
Please read ALL instructions before you begin installation.
You MUST determine if you need a Mounting Board prior to doing ANY installation. Due to many overlapping factors
such as the location of wall studs, the weight of a Barn door and the various types of trim used in homes, we
recommend using a Mounting Board in all situations. Track must be installed into Solid Blocking or Head Casing.
NOTE:
It is very important to determine whether you will be installing
a Mounting Board prior to installing the track. Please read
Mounting Board section prior to installation. If you do need to
install a Mounting Board, it MUST be installed rst.
NOTE NOTE
Fig. 2
Improper installation could cause serious
bodily harm.
WARNING
2 Ea.