SDS

GMF1033 GLIDDEN MAX FLEX ALL SURFACE SATIN EVERLASTING
Product name
1
Product code
Date of issue
Version
00470345
2 March 2023
Section 15. Regulatory information
SARA 313
SARA 313 notifications must not be detached from the SDS and any copying and redistribution of the SDS shall include
copying and redistribution of the notice attached to copies of the SDS subsequently redistributed.
Additional environmental information is contained on the Environmental Data Sheet for this product, which
can be obtained from your PPG representative.
California Prop. 65
Supplier notification
Chemical name
:
toluene
108-88-3
7 - 13
4-methylpentan-2-one
108-10-1
1 - 5
2-(propyloxy)ethanol
2807-30-9
0.5 - 1.5
ethylbenzene
100-41-4
0.1 - 1
CAS number
Concentration
2-(propyloxy)ethanol
≥1.0 - ≤4.4
FLAMMABLE LIQUIDS - Category 3
ACUTE TOXICITY (dermal) - Category 4
EYE IRRITATION - Category 2A
HNOC - Defatting irritant
ethylbenzene
<1.0
FLAMMABLE LIQUIDS - Category 2
ACUTE TOXICITY (inhalation) - Category 4
CARCINOGENICITY - Category 2
SPECIFIC TARGET ORGAN TOXICITY (REPEATED
EXPOSURE) - Category 2
ASPIRATION HAZARD - Category 1
HNOC - Defatting irritant
maleic anhydride
<0.10
COMBUSTIBLE DUSTS
ACUTE TOXICITY (oral) - Category 4
SKIN CORROSION - Category 1B
SERIOUS EYE DAMAGE - Category 1
RESPIRATORY SENSITIZATION - Category 1A
SKIN SENSITIZATION - Category 1A
SPECIFIC TARGET ORGAN TOXICITY (REPEATED
EXPOSURE) - Category 1
WARNING
: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
Section 16. Other information
Hazardous Material Information System (U.S.A.)
4
0
4
National Fire Protection Association (U.S.A.)
Health
Instability
Flammability
Health
Flammability
Physical hazards
Date of previous issue
No previous validation
:
Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4 representing significant hazards or
risks. Although HMIS® ratings and the associated label are not required on MSDSs or products leaving a facility under 29 CFR 1910.1200, the
preparer may choose to provide them. HMIS® ratings are to be used with a fully implemented HMIS® program. HMIS® is a registered trademark
and service mark of the American Coatings Association, Inc.
The customer is responsible for determining the PPE code for this material. For more information on HMIS®
Personal Protective Equipment (PPE) codes, consult the HMIS® Implementation Manual.
Organization that prepared
the SDS
:
EHS
:
:
:
:
:
:
3
*
3
0
( * ) - Chronic effects
United States
Page: 18/19