Assembly Instructions

globalindustrial.ca
Distribucion Industrial Globales S DE RL DE CF
LED BACK LIT PANEL, 0-10V DIMMABLE
040220
1
Assembly Instructions Instrucciones de Ensamblaje Directives d’assemblage
Customer Service
US: 800-645-2986
Servicio de atención al Cliente
México: 01.800.681.6940
Service à la clientèle
Canada: 888-645-2986
• To reduce the risk of death, personal injury or property
damage from fire, electric shock, falling parts, cuts/
abrasions, and other hazards read all warnings and
instructions.
• Installation, service and maintenance should be
performed by a qualified licensed electrician.
• DO NOT INSTALL DAMAGED PRODUCT!
WARNING:
RISK OF ELECTRICAL SHOCK
• Turn off electrical power at fuse or circuit breaker box
before wiring fixture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct.
• Make all electrical and grounded conn
ections in
accordance with the National Electrical Code and any
applicable local code requirements.
• All wiring connections should be capped with approved
wire connectors.
CAUTION:
RISK OF INJURY
• Wear gloves and safety glasses at all times when installing
or performing maintenance.
• Avoid direct eye exposure to the light source.
• Ensure fixtures are properly secured to T-bar grid and
ceiling, using wire, or aircraft cable capable of supporting
100 lbs. minimum.
CAUTION:
RISK OF FIRE
• Keep combustible and other materials that can burn away
from luminaire and lamp/lens
.
• Do not install insulation within 2 inches of light fixture.
• This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Remove the ceiling tile at an appropriate location where
the product is to be installed.
GENERAL SAFETY INFORMATION
T-Bar
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SPECIFICATIONS
Model 812406 - 2 x 2 Panel
0-10V Dimmable; 32W
120 Beam Angle; 125LM/W
4000 Lumens; CRI 80
4000K temp; DLC Premium
Model 812407 - 2 x 2 Panel
0-10V Dimmable; 32W
120 Beam Angle; 125LM/W
4000 Lumens; CRI 80
5000K temp; DLC Premium
Model 812408 - 2 x 4 Panel
0-10V Dimmable; 50W
120 Beam Angle; 125LM/W
6250 Lumens; CRI 80
4000K temp; DLC Premium
Model 812409 - 2 x 4 Panel
0-10V Dimmable; 50W
120 Beam Angle; 125LM/W
6250 Lumens; CRI 80
5000K temp; DLC Premium