- GMC Detail Sander INSTRUCTION MANUAL SA120

10
Maintenance
WARNING. Always ensure that the tool is switched
off and the plug is removed from the power point before
making any adjustments or maintenance procedures.
Keep the tool’s air vents unclogged and clean at
all times.
Regularly check to see if any dust or foreign matter
has entered the grills near the motor and around the
on/off switch. Use a soft brush to remove any
accumulated dust. Wear safety glasses to protect
your eyes whilst cleaning.
If the body of the tool needs cleaning, wipe it with
a soft damp cloth. A mild detergent can be used but
nothing like alcohol, petrol or other cleaning agent.
Never use caustic agents to clean plastic parts.
CAUTION. Water must never come into contact with
the tool. Lubricate all moving parts at regular intervals.
General Inspection
Regularly check that all the fixing screws are tight.
They may vibrate loose over time.
Power cord maintenance
If the supply cord needs replacing, the task must be carried
out by the manufacturer, the manufacturer’s agent, or an
authorised service centre in order to avoid a safety hazard.