User Guide

VXi BlueParrott
®
B450-XT User Guide
PAGE 8
GETTING STARTED
On/Off/Standby
Turn Headset On: Hold down the MFB for approximately 2-3 seconds until you hear a voice prompt,
“power on.” The red light will flash once every second.
Turn Headset Off (conserves battery power): Hold down the MFB for approximately 4–5 seconds
until you hear a voice prompt “power off.” A red light will flash 4 times and the headset will turn off.
Standby Mode: Once the headset is turned on (after the initial pairing), it will attempt to connect to
the last device that it was paired with, putting itself into Standby Mode.
Pairing with a Phone
When you turn your B450-XT on for the first time, or if its
Paired Device List has been cleared, it will go into pairing
mode automatically. You can pair the headset using NFC or
manually.
NFC (One-Touch) Pairing
1. Make sure that NFC is enabled on your cell phone.
2. Place the NFC zone of your cell phone against the NFC
zone of the headset and hold them together until your cell
phone registers the headset.
3. Follow the prompts on your cell phone to complete
pairing.
Note: NFC and One-Touch Pairing are dependent on your
cell phone. The size and sensitivity of your phone’s NFC
zone and the specific way to connect the headset may vary
between devices.
NFC Zone