Owner manual

Digital Series Narrowband Air/Fuel Ratio Gauge

For Product Numbers: GS-BD02 & GS-RD02

Wire Harness Color Code

Red:

12v Ignition (switched) Source (+)

Orange:

12v Dimmer (switched) Source (+) (optional)

Black:

Vehicle / Engine Ground (-)

Gray:

Connects to your Vehicle’s Narrowband Signal Wire

1. Disconnect the negative battery cable.

Connecting the Power Wire Harness

2. Air / Fuel Ratio: Connect the gray wire to the vehicle

oxygen sensor signal, before the catalytic convertor. You

may connect this wire directly to the ECU harness or splice

into the signal wire leaving the sensor. This wire color can

vary, be sure to consult your vehicle’s owner’s manual.

(0v ~ 1v Output - NARROW BAND ONLY)

 Note: If your vehicle does not have a narrowband o2

sensor, you will have to purchase a single wire

narrowband o2 sensor to complete this installation.

3. To make the wiring of your gauges easier you can

purchase an expandable circuit. This component easily fits

into your fuse panel and provides an additional fused power

wire for accessories such as gauges. The expandable circuit is

available for purchase at www.GlowShift.com.

4. Using automotive grade wiring (18 gauge); connect the

red wire to a positive 12 volt ignition (switched) source. It

may be connected to the fuse panel, an accessory wire, or

any positive 12 volt source that turns on and off with the

ignition.

5. Using automotive grade wiring (18 gauge); connect the

black wire to any good (unpainted) ground connection. You

may also route a wire directly to the negative side of the

vehicle’s battery.

6. The Night Time Dimming feature decreases the

brightness of the gauge face by 30%. Connect the orange

wire to the 12 volt positive headlamp source. This allows

the mode to be activated when the headlights come on. This

step is optional and will not affect operation of the gauge if

it is omitted.

 Note: Do not connect the orange wire to a dimmer

wheel. This will cause the gauge lighting to flicker.

7. Reconnect the vehicle's negative battery cable.

PAGE 1
Digital Series Narrowband Air/Fuel Ratio Gauge For Product Numbers: GS-BD02 & GS-RD02 Wire Harness Color Code Red: Black: 12v Ignition (switched) Source (+) Vehicle / Engine Ground (-) Orange: Gray: 12v Dimmer (switched) Source (+) (optional) Connects to your Vehicle’s Narrowband Signal Wire 4. Using automotive grade wiring (18 gauge); connect the red wire to a positive 12 volt ignition (switched) source.
PAGE 2
Additional Installation Information & Material Requirements  GlowShift Gauges Approved Conductor Wires: Successfully installing GlowShift Gauges may require lengths of wire (sizes and quantity depend on vehicle, gauge type, gauge location and / or sensor location). For correct and proper GlowShift Gauge installation and operation, the use of 18 Gauge (wire diameter) automotive grade conductor wire with sheathing is recommended for one or more gauges per vehicle.
PAGE 3
2. EXCLUSIVE REMEDY; ACCEPTANCE: Purchaser's exclusive remedy and GlowShift's sole obligation is to supply (or pay for) all labor necessary to repair any Product found to be defective within the repair or replacement fails to remedy the defect. Purchaser's failure to make a claim as provided in paragraph 1 above or continued use of the Product shall constitute an unqualified acceptance of such Product and a waiver by Purchaser of all claims thereto. 3.