User Manual

ManualsBrandsGlowShift ManualsCarTinted Series Air_Fuel Ratio Gauge

Tinted Series - Air / Fuel Ratio Gauge

For Product Numbers: GS-T02A

Wire Color Code

Black:

Vehicle Ground ( - )

Green:

Oxygen Sensor Signal

Red:

12v Ignition (switched) Source (+)

Orange:

12v Dimmer (switched) Source (+)

1. Disconnect the negative battery cable.

2. Using automotive grade wiring (18 gauge), connect

the red wire from the gauge to a positive 12 volt

ignition (switched) source. It may be connected to the

fuse panel, an accessory wire, or any positive 12 volt

source that turns on and off with the ignition switch of

the vehicle.

 If wiring to an un-fused source, install a 3 amp

fuse inline within 20 inches of the sources

connection. You may obtain an optional “add a

circuit” accessory. This component easily fits

into your fuse panel and provides an additional

fused power wire for accessories such as

gauges. This is available at

www.GlowShift.com or a local auto parts store.

3. (Optional) The dimming feature of the Tinted Series

decreases the brightness of the lighted gauge face by

30%. Connect the orange wire to a positive 12 volt

switched source. The most common installation is to

splice and connect to the 12 volt positive headlight

source. This step is completely optional.

 This gauge should never be connected to a dimmer.

Connecting the gauge to any type of dimmer switch

unit will cause the gauge to improperly function.

4. Air / Fuel Ratio: Connect the green wire to the vehicle

Oxygen sensor signal. You may connect directly to the ECU

harness or splice into the signal wire leaving the sensor. This is

usually the green wire on the Oxygen Sensor.

(0v ~ 1v Output - NARROW BAND SIGNAL ONLY)

5. Using automotive grade wiring (18 gauge), connect the

black wire from the gauge to any good (unpainted) ground

connection. You may also route a wire directly to the negative

side of the vehicle’s battery.

6. Reconnect the negative battery cable.

 Be sure all of your wiring is correct for proper gauge

operation.

 This gauge should never be connected to a dimmer.

Connecting the gauge to any type of dimmer switch unit will

cause the gauge to improperly function.

Summary of content (3 pages)

PAGE 1
Tinted Series - Air / Fuel Ratio Gauge For Product Numbers: GS-T02A Black: Red: Vehicle Ground ( - ) 12v Ignition (switched) Source (+) Wire Color Code Green: Oxygen Sensor Signal Orange: 12v Dimmer (switched) Source (+) 1. Disconnect the negative battery cable. 2. Using automotive grade wiring (18 gauge), connect the red wire from the gauge to a positive 12 volt ignition (switched) source.
PAGE 2
Additional Installation Information & Material Requirements  GlowShift Gauges Approved Conductor Wires: Successfully installing GlowShift Gauges may require lengths of wire (sizes and quantity depend on vehicle, gauge type, gauge location and / or sensor location). For correct and proper GlowShift Gauge installation and operation, the use of 18 Gauge (wire diameter) automotive grade conductor wire with sheathing is recommended for one or more gauges per vehicle.
PAGE 3
NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR ANY WARRANTY WITH REGARD TO ANY CLAIM OF INFRINGEMENT THAT MAY BE PROVIDED IN SECTION 2-312(3) OF THE UNIFORM COMMERCIAL CODE OR IN ANY OTHER STATE STATUTE.