Instruction Manual

ManualsBrandsGolden Lighting ManualsLighting1035-BA1 CH

For Customer Service, contact the place of purchase to arrange for replacement parts.

Fig. 3

Fig. 1

Fig. 2

Hanging the Fixture

1.Carefully remove the new fixture from the carton and the

yellow bag that holds all your parts. Check that all

parts are included as shown in the illustration and parts list.

2. Shut off power at the circuit breaker and remove the old

fixture from wall, including the old mounting strap.

3 Attach the Back Plate (B) to the Junction Box (C) by

using the two Junction Box Screws (D). Tighten the

screws securely.

CONNECTING THE WIRES (Fig. 2)

4. Attach the power supply wires to the fixture lead wires

by connecting BLACK to BLACK (or SMOOTH) and

WHITE to WHITE (or RIBBED).

5. Attached the GROUND wire (GREEN or COPPER) from

the Junction Box and the fixture Ground wire to the green

Ground Screw on the Back Plate (B) or connect both wires

together using the correct size of wire connectors.

NOTE: Twist the wires together in the same direction when

twist the wire connector onto the wires.

6. Tuck these wire connections neatly into the Junction Box.

FINISHING THE INSTALLATION (Fig. 3)

7. Place the fixture Front Plate (H), over the

Back Plate (B), and tighten with Mounting Screws (A).

8. Slide the Glass Shade (I) and Spacer (J) over

Socket (G), using Socket Wrench (N) to thread

Socket Ring (L) to Socket (G) until tight.

9. Install Bulb (M) in accordance with the

fixture's specifications .

10. Thread the Bulb Shield (K) to Socket (G).

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)

INSTALLATION INSTRUCTIONS

WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.

Fixture Name: Neeva 1035-BA1 CH

For Wall Mount Light Fixture

FIXTURE WIRES

HOUSE WIRES

Fig.2

JUNCTION BOX

BARE COPPER

(or Green)

GREEN

(Ground)

FIXTURE WIRES

SMOOTH ( or BLACK)

RIBBED ( or WHITE)

BLACK

(Hot)

WHITE

(Netural)

HOUSE WIRES

Summary of content (2 pages)

PAGE 1
H F IX TU RE W O US E W IRE S IRE S B A C F i g . 2 D INSTALLATION INSTRUCTIONS Fixture Name: Neeva 1035-BA1 CH For Wall Mount Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. Hanging the Fixture Fig. 1 JUNCTION BOX B A C 1.Carefully remove the new fixture from the carton and the yellow bag that holds all your parts. Check that all parts are included as shown in the illustration and parts list. 2.
PAGE 2
PARTS & ASSEMBLY SHEET Fixture Name: Neeva 1035-BA1 CH This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Green Ground Screw 1 ea #8-32N*H10mm Company Name:_______________________Co.