User guide

Canopy Wire Connectors Top Loop

1ea 3ea A4 Orange 1ea D50 x 60mm

Chain

Junction Box

Screw

Spring Washer

1ea 6ft x3.8mm 2ea 8/32" x 1" 1ea @15 x 2mm

Chain

Connector

Nipple

2ea @4.2X50mm 1ea @3/8 x 40mm x 5mm 1ea @3/8 x 455mm

Mounting Strap

w/ ground screw

Hex Nut

1ea 3/4"X4"

2ea @3/8 x 3mm

Part Needed Quantity

Reason why

( missing, scratched, broken glass, bent, bad finish)

Comments

PARTS LIST

Company Name:_______________________ Co. Account #:_____________

to be filled out by retailer

Fixture Name: Payton 1157-3P CH/AB

This fixture assembled PO:__________ Date: ________

PARTS & ASSEMBLY SHEET

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are

missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement

parts.

For Customer Service, contact the place of purchase to arrange for replacement

Canopy Loop

with Collar

FIXTURE ASSEMBLY INSTRUCTIONS

Read and review installation instruction sheet

before assembling the fixture.

1157-M1L CH/AB

Note: The wire cage and glass shade are

already assembled on the fixture body.

1. Thread the Top Loop (J) onto the nipple of

Fixture Body (M). Hand-tighten until snug.

Fig. 1

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Payton 1157-3P CH/AB This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________ Co.
PAGE 2
PARTS & ASSEMBLY SHEET Fixture Name: Payton 1157-3P CH/AB ASSEMBLING THE FIXTURE (Fig. 2) Fig. 2 2. Measure to determine the correct number of links needed for the proper hanging height. Use a pair of pliers to open one link of the Chain (K) then remove and discard the excess chain. 3. Use one Chain Connector (L) to attach one end of the chain to Top Loop (J) and close the chain connector. 4. Feed the fixture wires through the chain (every three links) and pull the wires until taut. 5.
PAGE 3
INSTALLATION INSTRUCTIONS Fixture Name: Payton 1157-6/4/3P CH/AB For Chandelier Light Fixture WARNING! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig.1) Fig. 1 1. Carefully remove the new fixture from the carton and the yellow bag that holds all parts. Check that all parts are included as shown in the illustration and Parts List. 2. Shut off the power at the circuit breaker and remove the old fixture from the ceiling, including the old mounting strap. 3.