Manual

ManualsBrandsGolden Lighting ManualsLighting1157-4P CH/AB

Canopy Wire Connectors Top Loop

1ea D5"×H1" 3ea P4 Orange 1ea W60 x 70mm

Chain

Junction Box

Screw

Spring Washer

1ea 6ft x3.8mm 2ea 8/32" x 1" 1ea @15 x 2mm

Chain

Connector

Nipple

2ea @4.2X50mm 1ea @3/8 x 40mm x 5mm 1ea @3/8 x 40mm

Mounting Strap

w/ ground screw

Hex Nut

1ea 3/4"X4"

2ea @3/8 x 3mm

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

1. Use Deco Nuts (S) to attach Circular End Cap

(T) to Metal Frame (N).

2. Carefully slide Glass Panels (U) into Metal

Frame (N). Then, lower the other Circular End

Cap (T) over the Metal Frame.

Note: Glass edges may be sharp. Wear gloves for

protection during installation to avoid injury.

If the glass can not be successfully placed into

the framework, please relax and adjust the iron

bar slightly. It is suggested that this be completed

by two people.

Fig. 1

For Customer Service, contact the place of purchase to arrange for replacement parts.

FIXTURE ASSEMBLY INSTRUCTIONS

Read and review installation instruction sheet before

assembling the fixture.

1157-4 CH/AB

PARTS & ASSEMBLY SHEET

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or

damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.

PARTS LIST

Company Name:_______________________ Co. Account #:_____________

to be filled out by retailer

Canopy Loop

with Collar

Fixture Name: Payton 1157-4P CH/AB

This fixture assembled PO:__________ Date: ________

Summary of content (3 pages)

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Payton 1157-4P CH/AB This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________ Co.
PAGE 2
PARTS & ASSEMBLY SHEET Fixture Name: Payton 1157-4P CH/AB ASSEMBLING THE FIXTURE (Fig. 2) Fig. 2 3. Thread Threaded Stem (P) into the coupling at centre of Fixture Body (O). 4. Thread the Top Loop (J) onto Stem (I) and (P). Hand-tighten until snug. 5. Lower the fixture over the glass cage, use the round Deco Nuts (M) to secure Arms (L) to the cage (N). 6. Measure to determine the correct number of links needed for the proper hanging height. Use a pair of pliers to open one link of Chain (K). Then, 7.
PAGE 3
INSTALLATION INSTRUCTIONS Fixture Name: Payton 1157-6/4/3P CH/AB For Chandelier Light Fixture WARNING! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig.1) Fig. 1 1. Carefully remove the new fixture from the carton and the yellow bag that holds all parts. Check that all parts are included as shown in the illustration and Parts List. 2. Shut off the power at the circuit breaker and remove the old fixture from the ceiling, including the old mounting strap. 3.