Instruction Manual

Canopy

1ea

Mounting

Screws

2ea Spacer 1ea

Chain 6ft Wire connectors 2ea Bottom cap 1ea

Chain connector

2ea

Canopy loop

and Canopy

loop collar

1ea Nipple 2ea

Mounting Strap 1ea Hex Nut 2ea Finial 1ea

Green screws 1ea Rubber washer 1ea Metal washer 1ea

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

FIXTURE ASSEMBLY INSTRUCTIONS

For Customer Service, contact the place of purchase to arrange for replacement parts.

NOTE: INSTALL THE GLASS ASSEMBLY

AFTER THE FIXTURE IS HUNG.

1. Thread the Center column (C) onto the Socket

Assembl

(

)

at the coupler

(

)

2. Feed the fixture wires through the Top loop (A)

and pull the wires until taut.

3. Then screw the Top Loop (A) onto the Nipple (B)

until tight.

1264-3P PW/RBZ

Read and review installation instruction sheet before

assembling the fixture.

Fig 1

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are

missing or damaged, please note onthis sheet and contact the place of purchase to arrange for

replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

PARTS & ASSEMBLY SHEET

This fixture assembled PO:__________ Date: ________

Fixture Name: Grace 1264-3P PW / RBZ

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Grace 1264-3P PW / RBZ This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Canopy Company Name:_______________________Co.
PAGE 2
PARTS & ASSEMBLY SHEET Fixture Name: 4. By measuring determine correct number of links Grace 1264-3P PW / RBZ Fig 2 A2 needed for proper hanging height. Use a pair of pliers to open one link of the Chain (C2) then B2 remove the excess Chain (C2) and discard it. 5. Use one chain connector (E2) to attach one end of the chain to the Top loop (D2) and close the E2 chain connector. 6. Feed the fixture wires through the Chain (every three links) and pull the wires until taut. C2 7.
PAGE 3
INSTALLATION INSTRUCTIONS Fixture Name: Grace 1264-3P PW / RBZ For Chandelier Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig.1) Fig. 1 1. Carefully remove the new fixture from the carton and the yellow bag that holds all parts. Check that all parts are included as shown JUNCTION BOX (CEILING) in the illustration and parts list. 2. Shut off the power at the circuit breaker and remove old fixture from ceiling, including the old mounting strap. A B 3.