Owner manual

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

Socket Tool

1ea 1-1/8"*3-5/8"

Wire connectors Mounting Screws Hex Nut

3ea P3 Orange 2ea 8#32-IP*1-1/2" 2ea 8#32-IP*H3mm

Mounting Strap Mounting Screws Deco Nut

1ea

∅

4"*H2mm 2ea 8#32-IP*1" 2ea 8#32-IP*H9mm

FIXTURE ASSEMBLY INSTRUCTIONS

Read and review installation instruction sheet, but do not

install before assembling the fixture.

1425-BA1 WG

ASSEMBLING THE FIXTURE (Fig.1)

1. Crystal Chains (T) are individually wrapped and must be

hung piece by piece. Remove Crystal Chain (T) from the

packaging and examine the chain for Connection Pin (U).

Drape Crystal Chain (T) over Arm (S) so that Connection

Pin (U) sits on top of Arm (S). This will ensure proper

draping length.

2. Install outer, Clear Glass (S) and inner, Opal Glass (R)

by sliding both pieces of glass over Socket (T). Place

Gasket (Q) inside Opal Glass (R) and over Socket (T).

Secure glass in place by tightening Socket Ring (P) over

Socket (T)，using Socket Tool (X).

Note: To avoid broken glass, do not over tighten Socket

Ring (P).

Fig 1

NOTE: INSTALL THE GLASS ASSEMBLY AFTER THE

FIXTURE IS HUNG.

Notice:

Please review the parts listing and check for all parts before assembling the fixture. If any parts are

missing or damaged, please note onthis sheet and contact the place of purchase to arrange for

replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

PARTS & ASSEMBLY SHEET

Fixture Name: Sancerre 1425-BA1 WG

This fixture assembled PO:__________ Date: ________

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Sancerre 1425-BA1 WG This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co.
PAGE 2
For Customer Service, contact the place of purchase to arrange for replacement parts.
PAGE 3
INSTALLATION INSTRUCTIONS Fixture Name: Sancerre 1425-BA1 WG For Wall Mount Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig.1) Fig. 1 1. Carefully remove the new fixture from the carton and the yellow bag that holds all your parts. Check that all parts are included as shown in the illustrations and the Parts and Assembly Sheet. 2. Shut off power at the circuit breaker and remove the old fixture from wall, including the old mounting strap. 3.