Manual

For Customer Service, contact the place of purchase to arrange for replacement parts.

1648-BA2 PARTS ASSEMBLY SHEET

PARTS & ASSEMBLY SHEET

This fixture assembled PO: Date:

Fixture Name: Olympia 1648-BA2 BUS

Notice: Please review the parts listing and check for all parts before assembling the fixture. If

any parts

are missing or damaged, please note on this sheet and contact the place of

purchase to arrange for replacement parts.

PARTS LIST

Company Name:_____________ Co Account#:__________

below to be filled out by retailer

Mounting Strap

1ea 102X320mm

Green Screw

G8/32*H8

㎜ 1ea

Mounting Screws

2ea

8/32"X5/8''mm

Wire Connectors

Orange 3ea

Mounting Screws

2ea 8/32X1"

Part Needed ______________________________ Quantity _________________________________

Reason why (missing, scratched, broken glass, bent, bad finish)

Comments __________________________________________________________________________

FIXTURE ASSEMBLY INSTRUCTIONS

Read and review installation instruction sheet

before assembling the fixture

1. Place Glass Shade (K) over the socket to

sit onto the glass holder.

2. Insert Candle Sleeve (L) onto the socket

and gently thread the sleeve onto the

socket to hold Glass Shade (K) into place.

3. Install the bulbs as per the fixtures

specifications.

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)

1648-BA2 BUS

Fig.1

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Olympia 1648-BA2 BUS This fixture assembled PO: Date: Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.
PAGE 2
INSTALLATION INSTRUCTIONS Fixture Name: Olympia 1648-BA2 BUS For Pendant Light Fixture WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER HANGING THE FIXTURE (Fig.1) 1. Carefully remove the new fixture from the carton along with the yellow bag that holds all of the parts. Check that all parts are included as shown in the illustration and the Parts and Assembly Sheet. 2. Shut off the power at the circuit breaker and completely remove the old fixture from the wall, including the old mounting strap. 3.