Installation Guide

ManualsBrandsGolden Lighting ManualsPendant Lighting2073-M1L GMT

For Customer Service, contact the place of purchase to arrange for replacement parts.

2073-M1L GMT PARTS AND ASSEMBLY SHEET

PARTS & ASSEMBLY SHEET

This fixture assembled PO: Date:

Fixture Name: SMYTH 2073-M1L GMT

Notice: Please review the Parts List and check for all parts before assembling the fixture. If any

parts

are missing or damaged, please note on this sheet and contact the place of purchase to

arrange for replacement parts.

PARTS LIST

Company Name:______________ Co Account#:__________

below to be filled out by retailer

Mounting Strap

Φ102 ㎜ 1ea

Green Screw

G8/32*H8

㎜ 1ea

Mounting Screws

H32

㎜

2ea H38

㎜

2ea

Wire Connectors

Orange 3ea

Hex Nut

G5/32*H4

㎜ 2ea

Deco Nut

Φ12*12 ㎜ 2ea

Canopy 1

L126*W126*H25 ㎜

” Rod Φ 12*L305

㎜

3ea

6” Rod Φ12*L152 ㎜

1ea

Part Needed ______________________________ Quantity _________________________________

Reason why (missing, scratched, broken glass, bent, bad finish)

Comments __________________________________________________________________________

FIXTURE ASSEMBLY INSTRUCTIONS

Read and review installation instruction sheet

before assembling the fixture

2073-M1L GMT

Fig.1

1. Measure to determine the

correct number of

rods needed for proper hanging height. There

are 3 optional 12" rods and a 6” rod included.

2. To shorten the fixture, trim the wires to the

desired length and add at least 8~10 inches.

You must use at least the 6” rod.

3. To lengthen the fixture, add additional rods.

(ROD-12 CDB) is available. To purchase

additional rods, please contact the retailer.

4. Pull the fixture’s wires through the rods.

5. Place Washer (G) between Rod (H) and

Frame (I). Thread Rod (H) into Frame (I) until

tight.

6. Place Washer (G) between each rod and

thread until tight.

7. Feed the fixture wires through Canopy (E)

and pull the wires until taut.

8. Thread Canopy (E) into Rod (H) until tight.

Summary of content (2 pages)

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: SMYTH 2073-M1L GMT This fixture assembled PO: Date: Notice: Please review the Parts List and check for all parts before assembling the fixture. If any parts are missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.
PAGE 2
INSTALLATION INSTRUCTIONS Fixture Name: SMYTH 2073-M1L GMT Mini Pendant Light Fixture WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER HANGING THE FIXTURE (Fig.1) 1. Carefully remove the new fixture from the carton as well as the yellow parts bag. Check that all parts are included as shown in the illustrations and the Parts and Assembly Sheet. 2. Shut off power at the circuit breaker and completely remove the old fixture from ceiling, including the old mounting strap. 3.