Owner's manual

3071-BA-140417 Instruction sheet

Mounting strap Mounting Screw Mounting screw

1ea 102X320mm 2ea 8/32"X5/8''mm 2ea 8/32X1"

Wire connnector

Green Ground

screw

3ea P3 Orange 1ea 8/32"X10mm

Part Needed Crystal Chain Quantity

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

PARTS & ASSEMBLY SHEET

This fixture assembled PO:__________ Date: ________

Fixture Name: ATHENA 3071-BA3 GG

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or

damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.

For Customer Service, contact the place of purchase to arrange for replacement parts.

NOTE: I

NSTALL THE GLASS ASSEMBLY AFTER

THE FIXTURE IS HUNG.

1. Hang Decorative Chains (I) onto Fixture Body (J).

2. Slide Glass Shade (H) over Socket (E) and secure in place

using Metal Spacer Ring (F) and Socket Ring (G). Screw on

Socket Ring (G) until tight.

3. Install the light bulb in accordance with the fixture's

specification. Bulb note:

Use a tissue or paper towel to hold the bulb and push down

into the socket. Oils or dirt can cause the bulb life to shorten.

Rubbing alcohol is recommended to clean the bulbs if dirty.

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)

PARTS LIST

Company Name:_______________________Co. Account #:_____________

below to be filled out by retailer

3071-BA3 GG

Read and review installation instruction sheet before

assembling the fixture.

FIXTURE ASSEMBLY INSTRUCTIONS

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: ATHENA 3071-BA3 GG This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co.
PAGE 2
INSTALLATION INSTRUCTIONS Fixture Name: ATHENA 3071-BA1/2/3/4/ GG For Wall Mount Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig. 1) 1. Fig. 1 Carefully remove the new fixture from the carton and the yellow A bag that holds all of your parts. Check that all parts are included as B shown in the illustrations and on the Parts and Assembly Sheet. 2.