Owner manual

ManualsBrandsGolden Lighting ManualsLighting3082-M1L PW

Mounting strap Mounting Screw Mounting screw

1ea 4" 2ea 8/32"X28mm 2ea 8/32X1"

Wire

connnector

Hex Nut Deco nut

(round nut)

3ea P3 Orange 2ea 8/32"X3.5mm 2ea @10mm

Canopy Rod Socket Ring Tool

1ea D 5-1/8"*H1"

3ea 12.7mm* H12“ 1ea 12.7mm* H6”

1ea D50mm*H110mm

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

For Customer Service, contact the place of purchase to arrange for replacements.

IXTURE

SSEMBLY

NSTRUCTIONS

Read and review installation instruction sheet

before assembling the fixture.

3082-M1L PW

1. By measuring determine correct number of rods

needed for proper hanging height.

* This fixture includes 4 rods (6", 12", 12", 12")

2. To shorten the fixture, slide the excess rods off the

wires. To lengthen, add additional rods.

3. Pull the fixture’s wires through Rods (H,I,J,K) until

taut and thread the rods together. Then thread the

rods onto Fixture Body (L), and the swivel joint on

Canopy (G).

4. Slide Glass Shade (M) over the socket of Fixture

Body (L).Then put Socket Ring (Q) into the Socket

Ring Tool (Y). Secure the glass and metal Socket

Cover (P) by threading Socket Ring (Q) unitl tight.

5. Attach Decorative Arms ( R) to the fixture base by

inserting and tightening Thumb Screws (O).

6. Install the light bulb in accordance with the fixture's

specification.

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING)

Fig. 1

NOTE: INSTALL THE GLASS ASSEMBLY

AFTER THE FIXTURE IS HUNG.

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing

or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

below to be filled out by retailer

PARTS & ASSEMBLY SHEET

Fixture Name: Wynn 3082-M1L PW

This fixture assembled PO:__________ Date: ________

Summary of content (2 pages)

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Wynn 3082-M1L PW This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co.
PAGE 2
INSTALLATION INSTRUCTIONS Fixture Name: Wynn 3082-M1L PW For Pendant Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig. 1) Fig. 1 OUTLET BOX (CEILING) 1. Carefully remove the new fixture from the carton and the yellow bag that holds all your parts. Check that all parts are included as shown in the illustration and on the Parts and Assembly Sheet. C 2.