Instructions / Assembly

Assembly Instructions: 3118-BA4 (Hines)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the
important notes above. Shut off the power at the circuit
breaker and completely remove the old xture from the
wall/ceiling, including the old mounting strap.
1. Mounting bracket (B) may be attached to backplate (G). If
so, use a screwdriver to remove deco nuts (H). Place the deco
nuts aside for future use. Leave mounting screws (A) in place
on mounting bracket (B). Mounting bracket (B) contains several
pairs of threaded holes. Find the pair of holes that matches the
spacing of the holes on your junction box and on backplate (G).
Pull the house wires through the center of mounting bracket (B).
Place mounting bracket (B) over the junction box and secure
mounting bracket (B) to the junction box with mounting screws
(D) and a screwdriver. Be sure that the mounting bracket is
level. Tighten the screws securely.
2. For extra security, use plastic anchors and mounting screws
(F) to secure mounting bracket (B) to the wall/ceiling.
CONNECTING THE WIRES
3.Haveanassistantsupportthexture’sweightwhile
completing the wiring. Refer to the wiring diagram and attach
thexture’swirestothepowersupplywiresfromthejunction
box. Connect black to black (transparent wire with black inner
thread or smooth); white to white (transparent wire with white
inner thread or ribbed); ground to ground (green, transparent
wire with green inner thread, or copper).
4. Twist the ends of the wire pairs together, and then twist on a
wire connector. Make sure all twists are in the same direction.
If there is no house ground wire coming from the junction box,
locate ground screw (E) on the mounting bracket/mounting
strapandwrapthexture’sgroundwirearoundtheground
screw. Use a screwdriver to tighten the top of ground screw (E)
onto the wires and into the mounting bracket/mounting strap.
Tuck the wires into the junction box.
FINISHING THE INSTALLATION
5.Placethexture’sbackplate(G)overmountingscrews(A)so
that mounting screws (A) protrude through the holes in the front
of backplate (G).
6. Thread deco nuts (H) onto mounting screws (A).
7. Slide shades (K) over sockets (J) and twist socket rings (L)
onto the threads of the sockets to secure in place.
Installlightbulbs(notprovided)inaccordancewiththexture’s
specications.Donotexceedthemaximumrecommended
wattage.
Your installation is now complete. Turn on the power and test
thexture.
Pivot shades and lock in place using thumbscrews (I).
For Customer Service, please
contact the place of purchase.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe
down the xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
How to Identify the Fixture’s Wires
Hot Neutral Ground
Smooth
Ribbed
Bare Metal,
Green, or
Green Inner
Thread
Black
White
Black Inner
Thread
White Inner
Thread
House Wires
Fixture Wires
Hot
*This xture may
be mounted on a
wall or ceiling.
JUNCTION
BOX
A
B
C
F
H
I
J
K
L
E
D
G