Owner manual

ManualsBrandsGolden Lighting ManualsLighting3890-ID3 GB

ASSEMBLY INSTALLATION

INSTRUCTIONS

MODE NO：3890-ID3 GB

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: Before installing, consult local electrical codes for wiring and grounding requirements.

Installation Steps

1. Carefully unpack your new Fixture and lay out all the

parts on a clear area. Take care not to loose any small

parts necessary for installation.

2. Shut off power at the Fuse Box or Circuit Breaker Box.

Remove the old fixture from ceiling, including the

Crossbar (D)

3. Attach the Crossbar (D) to the Ceiling Box using the

two Screws from the Outlet Box. The side of the

Crossbar (D) marked “GND” must face out.

4. Raise the Ceiling Pan such that the Outlet Box

and splices are completely covered.

5. While holding the Ceiling Pan toward the ceiling,

connect the electrical wires as follows. Connect the

black wire from the fixture to the black house (hot)

wire. Connect the white wire from the fixture wire

to the white (neutral) house wire. Make sure all wire

nuts are secured. You may wrap the connections with

electrical tape. If your outlet has a ground wire (green

or bare copper) connects fixtures Ground Wire to it.

Otherwise connect Fixture’s Ground Wire directly to

the Crossbar (D) using the Green Screw provided.

Tuck the wire connections neatly into the Ceiling Box

as you hold the Ceiling Pan assembly towardthe Ceiling.

6. Attach the Washer onto the Nipple, and securewith the Nut.

7. Attach the Cap (L) over the Nipple(G) and secure with

Finial (M).

8. Place Glass Shade onto Lamp Holder and secure

with Cap and Socket Ring

9. Install the light bulbs in accordance with the fixture’s

specifications. DO NOT EXCEED THE MAXIMUM

WATTAGE RATING!

10. Your installation is now complete. Return power to the

Ceiling Box and test the Fixture.

WARNING:

FIXTURE

WIRES

BARE COPPER

(Ground)

GREEN

(Ground)

WHITE

BLACK

HOUSE WIRES