Installation Guide

6068 Series Instructions_20111103m.xls

1ea ∅5"*H3/4" 2ea 8#32-IP*1"

3ea P3 Orange 2ea 5/32-IP*1-3/5" 2ea 5/32-IP*H3mm

3ea ∅11.7*H12" 1ea ∅11.7*H6" 2ea 5/32-IP*H10mm

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

For Customer Service, contact the place of purchase to arrange for replacement parts.

Read and review installation instruction sheet before

assembling the fixture.

6068-M1L GMT

1. By measuring determine correct number of rods

needed for proper hanging height.

* This fixture includes 4 rods (6", 12", 12", 12")

2. To shorten the fixture; slide the excess rods off the

wires. To lengthen add additional rods. The 12" rods are

optional.

3. Pull the fixture’s wires through the rods (G) until taut

and thread the rods together. Then thread to the fixture

coupler (H) at top of fixture and the swivel joint on

Canopy. (F)

4. Place the Glass Shade (J) over the Socket (I).

5. Install the light bulb in accordance with the fixture's

specification.

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)

Fig 1

NOTE: INSTALL THE GLASS ASSEMBLY

AFTER THE FIXTURE IS HUNG.

Rod

Deco sut

FIXTURE ASSEMBLY INSTRUCTIONS

Canopy Mounting screws Mounting strap

Wire connectors Mounting screws Hex sut

1ea

∅

4"*H2mm

This fixture assembled PO:__________ Date: ________

PARTS & ASSEMBLY SHEET

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing

or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

Fixture Name: Marco 6068-M1L GMT

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Marco 6068-M1L GMT This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co.
PAGE 2
INSTALLATION INSTRUCTIONS Fixture Name: Marco 6068-M1L GMT For Mini Pendant Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE as Pendant (Fig. 1) Fig. 1 1. Carefully remove the new fixture from the carton and the yellow bag that holds all your parts. Check that all parts are included as shown in the illustration and parts list. 2. Shut off power at the circuit breaker and remove the old fixture from ceiling, including the old mounting strap. 3.