Manual

ManualsBrandsGolden Lighting ManualsLighting8118-M1L BUS

8118-M1LPartsInstallation_10032011m.xls

1ea D 5-3/4"*H1-1/2" 2ea 8#32-IP*1" 1ea 1/8-IP*H60mm

1ea 1ft 3.8mm 3ea P3 Orange 1ea 1/4-IP*H60mm

2ea 5.8*H61mm 1ea 1-1/8"*H42mm 1ea W4-1/8"*E1"*H5mm

3ea 1/8-IP*H305mm

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

For Customer Service, contact the place of purchase to arrange for replacement parts.

ASSEMBLING THE FIXTURE (Fig.1)

1. By measuring determine correct number of

rods and chain needed for proper hanging height.

There is 1foot of chain and 2 optional 12" rods

included.

2. To shorten the fixture slide the excess 12" rods

off the wire.

3. To lengthen the fixture thread the additional

rods onto the wire or substitute longer chain for

the 1 foot length included.

Fig 1

NOTE: I

NSTALL THE GLASS ASSEMBLY

AFTER THE FIXTURE IS HUNG.

Read and review installation instruction sheet

before assembling the fixture.

8118-M1L BUS

Wire connectors NippleChain

FIXTURE ASSEMBLY INSTRUCTIONS

12" Rod

PARTS & ASSEMBLY SHEET

Notice:

Please review the parts listing and check for all parts before assembling the fixture. If any parts are

missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement

parts.

Fixture Name: Alston Place 8118-M1L BUS

PARTS LIST

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

Chain connector

Canopy loop

with Collar

Mounting strap

This fixture assembled PO:__________ Date: ________

Canopy Mounting Screws Top loop

These two Rods may

be removed

additional Rods may be

added.

ROD-12 BUS *

additional chain may be

added.

CHAIN-BUS-8118 *

*available for purchase

separately

Summary of content (3 pages)

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Alston Place 8118-M1L BUS This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts. Company Name:_______________________Co.
PAGE 2
PARTS & ASSEMBLY SHEET Fixture Name: Alston Place 8118-M1L BUS ASSEMBLING THE FIXTURE (Fig.2) Fig 2 4. Pull the fixture’s wire through the Rods until taut. 5. Thread Rod (U) into Frame (P)until tight. 6. Thread Rod (M)into Rod (U) until tight. repeat for any additional rods. 7. By measuring determine correct number of links needed for proper hanging height. Use a pair of pliers to open one link of the Chain (C2) then remove the excess Chain (C2) and discard it. 8.
PAGE 3
INSTALLATION INSTRUCTIONS Fixture Name: Alston Place 8118-M3/D5/6/9/M1L BUS For Chandelier Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig.1) Fig. 1 1. Carefully remove the new fixture from the carton and the yellow bag that holds all parts. Check that all parts are included as shown in the illustration and parts list. 2. Shut off the power at the circuit breaker and remove old fixture from ceiling, including the old mounting strap. 3.