User guide

ManualsBrandsGolden Lighting ManualsLighting8981-M1L GRM

Canopy Hex nut Wire connectors

1ea 130*H22mm 1ea 1/2"*H3mm 2ea A3 Orange

Mounting Strap

w/ ground screw

Nipple Chain connector

1ea 100*22*H4mm

/1ea 8/32"*H10mm

1ea 1/2"*H55mm 2ea 5*H58.5mm

Chain Mounting screws

Canopy Loop and

Canopy loop

collar

1ea 3.8mm*L72" 2ea 8/32"*H1" 1ea 1/2"*H46mm

12" Rod

3ea 12.7*H305mm

Crystal draping

A1 x 3pcs

Crystal draping

A2 x 3pcs

Crystal drops

B2 x 3pcs

Crystal drops

C1 x 1pcs

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

Crystal drops are included in parts

bag. (see crystal assembly

instruction)

8981-M1L BRI / GRM

Read and review installation instruction sheet, but do

not install before assembling the fixture.

FIXTURE ASSEMBLY INSTRUCTIONS

For Customer Service, contact the place of purchase to arrange for replacement parts.

NOTE: THE SHADE ASSEMBLY CAN BE DAMAGED BY

ROUGH HANDLING. USE CARE WHEN ASSEMBLING.

1. By measuring determine correct number of rods and

chain needed for proper hanging height. There are two

optional 12" rods included.

2.To shorten the fixture trim the wires to the desired length

plus at least 8~10 inches. You must use at least one Rod.

3. To lengthen the fixture add additional rods

(ROD-8981 CH) or additional chain (CHAIN-8981),

available separately.

Fig 1

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or

damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

PARTS & ASSEMBLY SHEET

This fixture assembled PO:__________ Date: ________

Fixture Name: Echelon 8981-M1L BRI / GRM

These two Rods may be

removed

additional Rods and/or

Chain may be added.

Summary of content (5 pages)

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Echelon 8981-M1L BRI / GRM This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co.
PAGE 2
PARTS & ASSEMBLY SHEET Fixture Name: 4. Pull the fixture’s wire through the Rods. Echelon 8981-M1L BRI / GRM Fig 2 5. Thread Rod (F) into Frame at (H) until tight. expanded view of assembly 6. Thread Rod (D) into Rod (F) until tight. repeat for any C E FA10 additional rods. 7. Feed the fixture wires through the Top loop (A) and pull A12 G A9 the wires until taut. 8. Thread Top loop (A) into Rod (C) until tight. H A11 9.
PAGE 3
INSTALLATION INSTRUCTIONS Fixture Name: Echelon 8981-3P, 5, 9, M1L BRI / GRM For Chandelier Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig.1) 1. Carefully remove the new fixture from the carton and the yellow bag that holds all parts. Check that all parts are included as shown in the illustration and parts list. 2. Shut off the power at the circuit breaker and remove old fixture from ceiling, including the old mounting strap. 3.
PAGE 4
PAGE 5