Installation Guide

ManualsBrandsGolden Lighting ManualsWall SconcesGolden Lighting Two Light Wall Sconce from the Echelon Collection

Mounting Strap

Deco nut

Mounting

Screw

2ea 8/32-IP*H1" 2ea 5/32-IP*1-1/4"

Mounting Screw Hex nut

Wire

connectors

1ea 8/32-IP*H10mm 2ea 5/32-IP*H3mm 2 ea A3 Orange

Green screw

1ea 8/32-IP*H10mm

Crystal drops

B2 x 6pcs

Crystal drops B3

x 2pcs

Crystal drops

C2 x 2pcs

Crystal drops

D6 x 1pcs

Part Needed Quantity

Reason why

( missing, scratched, broken glass, bent, bad finish)

Comments

8981-WSC BRI / GRM

Read and review installation instruction sheet before

assembling the fixture.

IXTURE

SSEMBLY

NSTRUCTIONS

For Customer Service, contact the place of purchase to arrange for replacement parts.

NOTE:

THE SHADE ASSEMBLY IS SHIPPED

INSTALLED ON THE FIXTURE.

1. Install the lighting bulbs in accordance with the

fixture's specification .

(DO NOT EXCEED MAXIMUM WATTAGE RATING!)

Crystal drops are included in

parts bag. (see crystal

assembly instruction)

PARTS & ASSEMBLY SHEET

This fixture assembled PO:__________ Date: ________

Fixture Name: Echelon 8981-WSC BRI / GRM

Notice:

Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or

damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

below to be filled out by retailer

100*22*H4mm

Copy of 8981-WSC PartsInstallation-20100812m

Summary of content (2 pages)

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Echelon 8981-WSC BRI / GRM This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts. Mounting Strap Company Name:_______________________Co.
PAGE 2
INSTALLATION INSTRUCTIONS Fixture Name: Echelon 8981-WSC BRI / GRM For Wall Mount Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig.1) Fig. 1 1. Carefully remove the new fixture from the carton and the yellow bag that holds all parts. Check that all parts are included as shown in the illustration and parts list. J 2. Shut off power at the circuit breaker and remove old fixture from wall including the old mounting strap. *in wall 3.