User Manual

9106 PartsInstallation-121208.xls

Mounting Strap Mounting screw Mounting screw

1ea L104*W24*H11mm 2ea 8/32-IP*H1" 2ea 5/32-IP*H1"

Hex nut Wire connnector Finial

2ea 5/32-IP*H3mm

3 ea A3 Orange 2ea 3/8-IP*H9mm

Canopy Rod Rod

1ea ∮127Dia*H20mm 3ea 12.7mmDia* H12“ 1ea 12.7mmDia* H6”

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

For Customer Service, contact the place of purchase to arrange for replacement parts.

IXTURE

SSEMBLY

NSTRUCTIONS

Read and review installation instruction sheet, but do not

install before assembling the fixture.

9106-5 PW

1. By measuring determine correct number of rods needed for

proper hanging height.

* This fixture includes 4 rods (6", 12", 12", 12")

2. To shorten the fixture; slide the excess rods off the wires.

To lengthen add additional rods.

NOTE: I

NSTALL THE GLASS ASSEMBLY AFTER

THE FIXTURE IS HUNG.

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or

damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

PARTS & ASSEMBLY SHEET

Fixture Name: Taylor 9106-5 PW

This fixture assembled PO:__________ Date: ________

These three Rods

may be removed

additional Rods

may be added.

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Taylor 9106-5 PW This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co.
PAGE 2
PARTS & ASSEMBLY SHEET continued Fixture Name: Taylor 9106-5 PW G 3. Pull the fixture’s wire through the Rods. F 4. Thread Rod (J) into Frame (K) until tight. 5. Thread Rod (I) into Rod (J) until tight. repeat for any additional rods. H 6. Feed the fixture wires through the Canopy (G) and pull the wires until taut. I 7. Thread Canopy (G) into Rod (H) until tight. * You may now install the fixture. J Note: Complete these remaining steps after the fixture is hung. 8.
PAGE 3
INSTALLATION INSTRUCTIONS Fixture Name: Taylor 9106-M3,5,9,M1L PW For Pendant Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig. 1) 1. Carefully remove the new fixture from the carton and the yellow bag that holds all your parts. Check that all parts are included as shown in the illustration and parts list. 2. Shut off power at the circuit breaker and remove the old fixture from ceiling, including the old mounting strap. 3.