User guide

9106 PartsInstallation-121208.xls

Circular Mounting

Strap

Mounting screw Mounting screw

1ea Φ4"*H1.2mm 2ea 8/32-IP*1" 2ea 5/32-IP*1"

Hex nut Wire connnector Deco nuts

2ea 5/32-IP*H3mm

3ea A3 Orange

2ea 5/32-IP*H9mm

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

PARTS LIST

Company Name:_______________________Co. Account #:_____________

below to be filled out by retailer

Fixture Name: Taylor 9106-BA3 PW

PARTS & ASSEMBLY SHEET

This fixture assembled PO:__________ Date: ________

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or

damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.

9106-BA3 PW

Read and review installation instruction sheet before

assembling the fixture.

FIXTURE ASSEMBLY INSTRUCTIONS

For Customer Service, contact the place of purchase to arrange for replacement parts.

NOTE: INSTALL THE GLASS ASSEMBLY AFTER

THE FIXTURE IS HUNG.

1.Slide the Glass Shade (K) over Socket (G) and secure it by

threading the Socket Ring (I) onto the Threaded Socket (G)

until tight.

2. Install the light bulbs in accordance with the fixture's

specification.

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Taylor 9106-BA3 PW This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co.
PAGE 2
INSTALLATION INSTRUCTIONS Fixture Name: Taylor 9106-BA3 PW For Wall Mount Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig 1) Fig. 1 1. Carefully remove the new fixture from the carton and the yellow bag that holes all your parts. Check that all parts are included as shown in the illustration and parts list. 2. Shut off power at the circuit breaker and remove the old fixture from wall, including the old mounting strap. 3.