Instructions / Assembly

ALL LOCKING MECHANISMS MUST BE ENGAGED BEFORE USING
THE LADDER.
LADDER CONFIGURATIONS
STAIRWAY
DO NOT ADJUST THE OUTER LADDER OR RAIL LOCKS WITHOUT SECURE HOLD
OF THE INNER LADDER.
KEEP ALL BODY PARTS CLEAR OF SLIDING STEPS AND RUNGS DURING ADJUSTMENT.
NEVER USE THE LADDER IN STAIRWAY IF STEPS ARE NOT LEVEL. YOU CAN LOSE
YOUR BALANCE.
PROPER SET-UP AND HEIGHT ADJUSTMENTS
Figure 15 Figure 16
From the storage position (see Figure 15), unlock both adjustable hinges to
disengage the locks as indicated in Figure 1. Pull the two sections of the
ladder apart until both hinges snap into place and securely lock
(see Figure 16).
To increase the height of the ladder, unlock the rail locks on one side of the
ladder and tip the ladder to its side to allow the outer section to drop to
your desired height (see Figure 17). When you are at your desired height,
lock the rail locks.
Adjust the other side of the ladder accordingly to fit staircase.
The ladder is properly aligned when the ladder steps are level as show in
Figure 18.
Visually make sure the rail locks are in the locked position and
no red is showing.
To return the ladder back to its lowest position, reverse the process above.
Figure 17 Figure 18
DANGER
WARNING
WARNING
WARNING
TODOS LOS MECANISMOS DE BLOQUEO TIENE QUE ESTAR FIJADOS
ANTES DE USAR LA ESCALERA.
CONFIGURACIONES DE LA ESCALERA
ESCALERA FIJA
NO AJUSTES LOS BLOQUEOS DE RIEL NI DE LA ESCALERA EXTERIOR SIN
SOSTENER CON SEGURIDAD LA ESCALERA INTERNA.
AL AJUSTAR, MANTÉN TODAS LAS PARTES DEL ARMAZÓN LIBRES DE PELDAÑOS Y
ESCALONES DESLIZANTES.
NUNCA USES LA ESCALERA EN EL MODO FIJO SI LOS PELDAÑOS NO ESTÁN AL
MISMO NIVEL.
INSTALACIÓN Y AJUSTES DE ALTURA ADECUADOS
Figura 15 Figura 16
Desde la posición de almacenaje (Ver Figura 15), desbloquea ambas bisagras
ajustables para liberar los bloqueos como se indica en la Figura 1. Separa las
dos secciones de la escalera tirando de ellas hasta que ambas bisagras
encajen en su lugar y queden bloqueadas con seguridad (Ver Figura 16).
Para incrementar la altura de la escalera, libera los bloqueos de riel a un lado
de la escalera e inclínala de lado para permitir que la sección exterior caiga a
la altura deseada (Ver Figura 17). Al alcanzar la altura deseada, fija los
bloqueos de riel.
Ajusta en consecuencia el otro lado de la escalera hasta alcanzar la
posición fijada.
La escalera está bien alineada si sus peldaños están nivelados como se
muestra en la Figura 18.
Para colocar la escalera en su posición anterior más baja, procede a la inversa
de como se indicó más arriba.
Figura 17 Figura 18
PELIGRO
ADVERTENCIA
ADVERTENCIA
ADVERTENCIA
11
11