Datasheet

GMC-I Messtechnik GmbH 9
SECUTEST BASE / PRO and SECULIFE ST BASE(25)
Test Instruments for Measuring Electrical Safety of Devices
SECU-cal 10 (Z715A) Calibration Adapter
The calibration adapter is
used for testing the mea-
suring uncertainty of test
instruments in accordance
with DIN VDE 0701-0702 /
IEC 62353 (VDE 0751). As
a rule, these instruments
must be tested once each
year, as well as for certifi-
cation in accordance with the ISO 9000 quality standard, as set
forth by accident prevention regulation DGUV provision 3 (previ-
ously BGV A3).
All limit values for the required tests per DIN VDE, as well as pro-
tective conductor resistance, insulation resistance, equivalent
leakage current, differential and/or touch as well as housing leak-
age current, must be tested.
SECULOAD-N (Z745R) Test Adapter
Test Adapter for testing
open-circuit voltage at
welding units per IEC /
EN 60974.
In combination with the
test instrument, the test
adapter is used for testing
welding units in accor-
dance with the IEC/EN 60974-4 standard. This standard stipu-
lates that peak values for open-circuit voltage may not exceed the
limit values, regardless of the utilized settings.
SECUTEST BASE(10)/PRO/SECULIFE ST BASE(25) testing instrument
includes a test sequence for testing welding instruments with this
adapter.
The peak value rectifier of the SECULOAD-N uses rectifier diode
1N 4007 recommended by the standard. This diode is a power
rectifier diode and, due to its design principle, only suitable for
voltage sources with a low clock rate in the line frequency range
or for voltage sources with conventional transformers.
EL1 (Z723A) Adapter for Testing Single-Phase Extension Cables
AT3-III-E (Z745S) 3-phase
Current Adapter
Test adapter for active and
passive testing of Single
and 3-Phase Electric
Devices and Extension
Cables in Combination
with SECUTEST... Test
Instruments
Operation is simple and
safe. The test adapter is
connected to a 3-phase 16
A mains outlet, and to the
respective test instrument.
Testing is performed with-
out reversing polarity at the
device under test, either automatically or manually, and is con-
trolled by the test sequence of the utilized test instrument. Safety
shutdown occurs if the factory preset residual current value is
exceeded.
SORTIMO L-BOXX (Z503D)
Plastic system case Out-
side dimensions:
W x H x D
450 x 255 x 355 mm
Foam insert Z701D for tes-
ter and accessories, has to
be ordered seperately, see
below.
Foam insert for SORTIMO L-BOXX (Z701D)
F2000 Universal Carrying Pouch (Z700D)
Test instrument, plug
inserts, measuring adapt-
ers, replacement batter-
ies, recording charts etc.
can be stored in a clear-cut
fashion and conveniently
transported in the F2000
carrying pouch.
Outside dimensions:
380 x 310 x 200 mm
(without buckles,
handle
and carrying strap)