User Manual

GMC-I Messtechnik GmbH 17
Setting the Interval Parameters
seleCt range 300 mV  15 V   1nt
Initial value:
1nt start 02.000 V  
Final value: 1nt end 10.000 V  
Steps:
1nt steps 03.0  
Dwell time:
1nt t1 00.05 min.s  
Repetition:
1nt mode auto  manual
(Auto = automatic sequence, MAnuAL = manual sequence)
Manually Controlled Interval Sequence
After entering all parameters for the “manual interval sequence”
output function (
1nt mode = manual ) and starting the function with
the key, the individual steps are triggered with the  and
 keys. The relationship between the output signal and each of
the key operations is depicted with the help of the following exam-
ple.
Example of a Manually Controlled Interval Sequence
Key
1 When 1nt
ready is displayed:
Start the sequence by pressing .
2 The sequence is continued in the corresponding direction by
pressing the  or the  key.
3 Stop the interval sequence by pressing .
SELECT
ESC
CAL
SETUP
OUT
ENTER
OUT
ENTER
OUT
ENTER
OUT
ENTER
OUT
ENTER
OUT
ENTER
4
8
12
16
20
t[s]
I
Source
manual stop
[mA]
➀➂
ESC
➁
Time intervals depend upon the operator (only
identical in automatic mode).
  
OUT
ENTER
SELECT
ESC