User Manual

GMC-I Messtechnik GmbH 33
14.4 USB X-TRA Bidirectional Interface Adapter
This adapter makes it possible to connect the calibrator to a USB
port at a PC. The adapter allows for data transmission between
the calibrator and the PC.
14.5 METRAwin90-2 Software (in preparation)
This software allows for paperless documentation and
management of calibration results, as well as remote control of
the calibrator.
Calibrator sequence controls can be implemented online, or
offline after downloading complete calibration sequences.
The following conditions must be fulfilled in order to allow for use
of METRAwin90-2 :
Hardware, Software and Driver
• IBM compatible Windows PC, Pentium processor with
200 MHz or better and at least 64 MB RAM
• SVGA monitor with at least 1024 x 768 pixels
• Hard disk with at least 40 MB available memory
•CD-ROM drive
• Microsoft compatible mouse
• Windows-supported printer
• One USB port for use of the USB X-
TRA
– with installed driver USB2COM (virtual COM interface) for
Windows 2000, XP and VISTA
or
– with Driver Control for Windows XP, VISTA and 7.