Installation And Safety Instructions

4
STEP 1A - CONCRETE CEILING
SWITCH OFF THE ELECTRICAL MAINS AT THE
CIRCUIT BREAKER FUSE BOX.
IMPORTANT : SCREWS & NUTS MUST BE
TIGHTENED TILL SNUG
STEP 1B - WOODEN CEILING
SWITCH OFF THE ELECTRICAL MAINS AT THE
CIRCUIT BREAKER FUSE BOX.
IMPORTANT : SCREWS MUST BE TIGHTENED
TILL SNUG
3
INSTALLATION INSTRUCTION
Flat Washers (3)
Expansion Bolts (2)
Nuts (5)
Mounting
Bracket (1)
Spring Washers (4)
Washers (3)
Self Tapping
Screw (2)
Mounting
Bracket (1)
1) Use the Mounting Bracket (1) as a guide,
mark the spots where the 4 Self Tapping
Screws (2) will be drilled.
2) Remove the Mounting Bracket (1), drill 4
holes for 3MM diameter, install the mounting
bracket onto wooden ceiling with the 4 Self
Tapping Screws (2) & Washers (3).
1) Use the Mounting Bracket (1) as a guide,
mark the spots where the 4 Expansion Bolts (2)
will be drilled.
2) Remove the Mounting Bracket (1), drill 4
holes and insert 4 Expansion Bolts (2) into the
concrete ceiling, install the mounting bracket
and secure with Flat Washers (3), Spring
Washers (4) and Nuts (5).
INSTALLATION INSTRUCTION
Canopy (4)
Nut (11)
Clevis pin (12)
Flat Washer (9)
Spring Washer (10)
Coupling cover (8)
Canopy Ring (5)
Downrod (7)
Screw (1)
Lock Pin (2)
Hanger Ball (3)
Coupling (17)
Set Screws (13)
Bulb(18)
Column (6)
Screw (14)
Rod (15)
Hosing (19)