Installation And Safety Instructions

STEP 4
SWITCH OFF THE ELECTRICAL MAINS AT
THE CIRCUIT BREAKER FUSE BOX.
1) Connect wires from receiver to
2) Insert the controller into the
space of the mounting bracket, and
tidy up the wiring.
STEP 5
1) Carefully push the canopy to the
bottom of the mounting bracket,
make two sliding holes aligned to the
two prominent screws on the
mounting bracket, and then turn
clockwise until tight.
2) Push the canopy ring to the
bottom of the canopy, slide the inner
holes aligned to the two prominent
screws on the mounting bracket
again, and turn the canopy ring
clockwise until tight.
7
INSTALLATION INSTRUCTION
learned the frequency, the receiver will “Beep”,
8
TRANSMITTER FUNCTION
TRANSMITTER SETTING
This DC motor is equipped with self-learning frequency function transmitter. Read all the steps
BEFORE proceeding. Each step must be followed exactly in order to program the transmitter.
To use factory pre-programmed setting – Skip the below programming steps. Insert battery
into transmitter, turn on the power supply to fan and it is ready to use.
FIRST ONE USE INSTRUCTION
1) Dial up to position“O”, it is on/off only for the lighting,
and it is the brightest of the light.
2) Dial down to position“D”, the brightness of the light can
be control low or high.
SECOND ONE USE INSTRUCTION
1) If you have more than 1 unit of this fan model in close
proximity, it is equipped self-learning, please don’t press
any key when self-learning.
2) To set the second one down to the position of "1" (set to
"0" position on one product when used directly).
3) Turn on the power of the light fan.
4) Within 30 sec after the “Beep”, press and hold the
LEARN button for 3 sec. Once the receiver has detected and
Programming/self-learning process is completed and fan is
ready to use.
ATTENTION
1) If the fan is not responding to the transmitter. Turn off the power supply to fan for 30
sec and then restore power & reset the transmitter.
2) If long time not to use the transmitter, please take the battery out.
C
R
2
0
3
2
3V
LEARN
O0
D1
power supply with wire connectors.
Canopy
Canopy Ring
Controller
Neutral (White)
Live (Black)
Earth (Green/Yellow)
MOTOR U
FOR LIGHT L
FOR LIGHT N
G
MOTOR W
MOTOR V
AC IN N
AC IN L
Controller
Hanger Ball
G
Light
Fan
mounting bracket