Operating Guide

Maintenance
3A6419B EN 35
ProXChange Removal Tool
An integrated tool is included in the frame to
remove the ProXChange packing assembly.
See ProXChange Pump manual for
complete repair instructions.
Pump Installation
1. Slide pump assembly onto the
mounting pins.
a. Move pump rod up or down until
cap is level with the opening in the
yoke.
b. Push on pump rod to slide pump
assembly back on to mounting
pins.
2. Swing Easy Access Door closed while
pushing the entire door down.
3. Install hose, suction tube, and drain
tube.
4. Plug sprayer into power source.
NOTE: Door must be fully closed and
latched before sprayer will operate.
ti26931a
ti27036a
ti27037a
1
ti27478a
2
3