Full Product Manual

Setup
3A3258J 11
Setup
1. Connect air hose and material hose to
sprayer air and material hose outlets.
2. Open air valve.
3. Connect air hose to gun.
4. Connect material hose to gun.
5. Make sure burp guard is installed.
6. Install spray nozzle or wide spray disc.
See Recommended Nozzle Selection
Charts, page 15.
NOTICE
•
Do not store sprayer under pressure.
• Do not allow material to dry inside
pump, hoses, gun or spray system.
• When operating a RTX1400SI and you
are going to stop spraying for more than
five minutes turn sprayer OFF to
prevent shortened pump life.
ti27342a
ti27341a
ti27343a
Before adding material to the hopper,
install the burp guard. When only a small
amount of material remains in the hopper,
the burp guard prevents material from
shooting out when the unit is turned off.
This material could splash in the operator’s
eyes or on skin, or into the air.
ti27344a
ti27345a