Full Product Manual

Mixing Material
3A3258J 13
Mixing Material
NOTE: Correct material mixture is essential.
The pump will not operate if the mixture is too
thick.
• Mix the material in a separate container
before pouring it into hopper.
• Use Material Thickness Gauge to
determine if mixture is thin enough to
spray.
• The Material Thickness Gauge will only
determine if the material is thin enough
to pass through the pump. For some
applications or for higher speed
spraying, your mixture may need to be
thinner.
• For best results, do not use partial bags
of material.
1. Mix the material and water in a
separate container.
Dry Mix - 40 lb (18 kg) bag
Carefully mix texture material and water
according to manufacturer instructions
on bag.
Premix
Slowly add approximately 2 to 4 quarts
(1.9 to 3.8 liters) of water to a 5 gallon
(18.9 liter) bucket of premix.
2. Agitate to mix, using a half-inch, variable
speed drill with mixing paddle, to a
smooth, lump-free consistency.
3. Allow ceiling texture to set for at least 15
minutes. Then remix prior to use.
4. After texture material is thoroughly
mixed, gently set ball end of Material
Thickness Gauge on surface of mixture.
ti2496b
40 lb.
TEXTURE MIX
5 GAL
PREMIX
5
GAL
ti2493b
ti2497b