Full Product Manual

Shutdown and Cleanup
3A3258J 19
3. Plug opening on bottom of material
hopper with your hand.
4. Take hopper to cleaning area for
cleaning.
5. After cleaning material hopper, position it
on sprayer handle first.
6. Hand tighten fitting.
Transporting Sprayer
The handle and hopper can be removed from
the sprayer for storage or transporting.
NOTE: The handle on the RTX2000pi and
RTX 2500pi has semi-permanent screws. It is
not recommended that the handle be
removed.
1. Remove hopper see Clean Material
Hopper, page 18.
2. Loosen screws on either side of handle.
3. Spread handle apart and remove.
ti27388a
ti27389a
ti27390a
NOTICE
Water or material remaining in unit when
temperatures are below freezing can
damage motor and/or delay pump startup.
Do not allow unit to freeze.
To ensure water and material are com-
pletely drained out of unit:
1. Remove material hose from sprayer.
2. Remove pump hose from sprayer.
Empty hose and reinstall.
3. Remove hopper and drain.
NOTICE
Do not lift sprayer by the handle. To prevent
sprayer damage, handle should only be used
to push or pull the sprayer.
ti27398a