Full Product Manual

Operation
3A3258D 15
Operation
Texture Spraying
Recommended Nozzle Selection Charts
RTX1400si
1
Control air volume with gun air valve.
2
For more material volume try a larger nozzle.
RTX2000pi
Adjusting the System
Sufficient fluid output (volume and pressure)
and good atomization are a balance of
atomizing air, material thickness/material
flow and nozzle selection. Achieving the
correct balance for your application requires
experimentation to achieve desired results.
Keep in mind these important points when
adjusting gun:
• Select proper nozzle for your
application. See Nozzle Selection
Chart. Remember, the larger the
nozzle, the heavier the pattern.
• Start sprayer with gun air flow valve
completely open. Trigger sprayer gun.
If needed, slowly close gun air flow until
you get a good spray pattern. Use mini-
mum amount of air at spray gun to
achieve proper spray pattern and to
minimize bounce back.
+ Test spray pattern on cardboard.
Hold gun 18 to 24 in. (45.7 to 61 cm)
from surface. Use this spraying dis-
tance for most applications.
• Air and material flow adjustments are
made at the gun on all units.
+ Opening air valve increases air flow
through gun, which decreases texture
material flow through pump.
Application Nozzle Size
2
Air Volume
1
Application Nozzle Size
2
Air Volume
1
Simulated
Acoustic
6 mm, white
(fine to medium)
8 mm, gray
(coarse)
medium to high Splatter coat 6 mm, white
8 mm, gray
low to medium
Orange peel 4 mm, beige,
6 mm, white
medium to high Knockdown 6 mm, white
8 mm, gray
12 mm, black
low
Application WideTex™ Disc Nozzle (mm) Air Volume
Standard Hardened
Simulated Acoustic - Fine W6 W6H 4high
- Medium W8 W8H 6high
- Course W10 W10H 8- 10 high
Fog W4 W4H 3high
Orange peel W4 or W6 W4H or W6H 3 - 8 medium to high
Splatter coat W6 or W8 W6H or W8H 6 - 10 low to medium
Knockdown W6 or W8 W6H or W8H 6 - 8 low