User Manual

Setup
12 3A3258C
7. Pour one gallon (four liters) of water into
the material hopper.
8. Turn ON/OFF switch to ON position.
9. Close gun air valve. On the RTX2000pi
open the prime valve on the gun.
10. Point gun into waste bucket and pull
trigger to pump water through the
system. Continue to trigger gun until
material hopper is empty.
11. Add pre-mixed texture mix to material
hopper. See Mixing Material, page 13.
12. Continue to trigger gun and spray into
waste bucket until a steady stream of
material sprays out of gun.
13. Release trigger.
IMPORTANT! Fluid/air flow will be restricted
if the material/air hoses are restricted or
kinked.
NOTICE
To prevent pump damage, before adding
material or starting unit in cold weather, run
warm water through the pump.
ti27346a
ti27380a
ti27383a
ti27381a
ti27382a