User Manual
Shutdown and Cleanup
3A3258C 17
Shutdown and Cleanup
NOTE: Keep pump and hose clean when
switching between simulated acoustic,
knockdown and orange peel applications. A
dirty pump can release particles of texture
into the finish.
• To increase pump life, life turn power
OFF when not spraying.
• Before removing material hose, perform
Pressure Relief Procedure, page 9.
Make certain there is no material in the
hose.
• To keep sprayer in good operating
condition, always clean it throughly and
prepare it properly for storage.
When you have finished spraying:
1. Open gun air valve.
2. Turn ON/OFF switch to ON position.
3. Close gun air valve.
4. Trigger gun into bucket until most of
texture mix is pumped out.
5. Fill material hopper with 2-4 gallons of
clean water.
ti27341a
ti27380a
ti27383a
ti27381a
ti27346a