User Manual

Shutdown and Cleanup
18 3A3258C
6. Spray inside material hopper to circulate
water through gun and hose. While
circulating water, use gun to clean
material hopper.
7. Partially open gun air valve to use air to
achieve better cleaning results.
8. Spray water into a waste bucket to empty
material hopper.
NOTE: A soft brush can be used to loosen
dried on material.
9. Turn ON/OFF switch to OFF position.
10. Open gun air valve. Perform pressure
relief procedure, Pressure Relief
Procedure, page 9.
Clean Material Hopper
Material hopper can be removed for easy
cleaning.
1. Loosen bottom fitting
2. Lift material hopper straight up, off the
unit.
ti27339a
ti27385a
ti27381a
Air hose fittings can get hot. Allow sprayer
to cool down 15 minutes before removing
air hose.
ti27340a
ti27386a
ti27387a