Full Product Manual

Setup
12 3A4967E
Fluid and Work Piece
Preparation
• Strain fluids before spraying. This
includes colors, reducers and
hardeners.
• Use a slower drying reducer or thinner to
compensate for the faster drying time
caused by the warm air of the turbine. Do
not over reduce.
• Sprayer performance varies with the
viscosity of the material sprayed and the
length of the hose. To prevent pressure
drop, use hose supplied with sprayer.
• Most material manufacturers provide
recommendations for their materials.
Follow these recommendations.
• For proper adhesion, ensure surface of
work piece is completely clean.
Fluid Set Selection
For best spray performance, select proper
fluid set for fluid being sprayed. Reference
Fluid Set Selection Guide in HVLP Edge II
gun manual provided with sprayer. Fluid Set
numbers are marked on fluid needles and
nozzles.