Full Product Manual

How to Spray
3A4967E 19
How to Spray
Take a few moments prior to spraying and
review these simple tips to ensure your
spraying project is a success.
Spray Techniques
Use a piece of scrap cardboard to practice
spraying techniques before spraying the
work piece.
• For Standard and ProContractor
models, use TurboControl to adjust
pressure.
• For ProComp models using the remote
cup, use TurboControl and pressure
regulator on remote cup to adjust
pressure.
• Always spray with the least amount of
pressure required to provide the desired
spray pattern and rate of application.
Spraying at pressures higher than
necessary wastes material and can
result in an orange peel finish.
• To adjust spray gun pattern, see HVLP
Edge II gun manual provided with
sprayer.
• Aim gun straight at surface. Tilting gun to
direct spray angle causes an uneven
finish
• Flex wrist to keep gun pointed straight.
Fanning gun to direct spray at angle
causes uneven finish.
Triggering Gun
Pull trigger after starting stroke. Release
trigger before end of strike. Gun must be
moving when trigger is pulled and released.
NOTE: To prevent uneven spray pattern,
start and end stroke off of work piece surface.
The turbine motor generates sparks.
These sparks can ignite flammable fumes.
• Keep sprayer in a well ventilated area.
• Keep sprayer at least 20 feet (6m) from
spray area. Use additional hose if
necessary.
THICK
UNEVEN FINISH EVEN FINISH
THIN
EVEN
ti30761a
UNEVEN FINISH
EVEN FINISH
THICKTHIN THIN
ti30762a
ti30763a