Manual

13
2002 Top Dry Service School
VERSION: 1.00 RELEASE DATE: SEPTEMBER 16, 1997
1.) We changed resistor number 107 on the display board from 10K to 3.0K to allow the contrast to work without resetting the
computer.
2.). Put in a contrast adjustment for the display. While turning the control power on, hold in on the screens key, and this will enter
the contrast adjustment mode. Now use the UP/DOWN arrow keys to adjust. If the screen is solid black press the down arrow
key, if nothing appears on the screen press the up arrow keys. NOTE: You cannot hold in on the UP/DOWN arrow keys to
adjust, you must continue to press and then release them or nothing will happen.
3.) Put Software in for 3
rd
Fan and Heater.
*********************************************************************
VERSION: 0.05 RELEASE DATE: 1996
This was the first version released for customer operation. This particular version could only control 2 Fan and Heaters
NOTE: remember to always do a hard reboot after installing new software to the display board or the IO
board. Shut off all gas valves when installing new software in all burners.
Software revisions