Owner manual

ManualsBrandsGreat Northern Popcorn ManualsKitchen4104 GNP 11 Roller Cover

Hot Dog Roller Cover Assembly Manual

4089 GNP Hotdog 5 Roller Cover

For use with 4091 GAP 5 Roller with Cover / 4090 GAP 5 Roller

4088 GNP Hotdog 7 Roller Cover

For use with 4092 GNP 7 Roller with Cover / 4078 GNP Hotdog 7 Roll Machine

4087 GNP Hotdog 9 Roll Cover

For use with 4093 GNP 9 Roller with Cover / 4079 GNP Hotdog 9 Roll Machine

4104 GNP 11 Roller Cover

For use with 4106 GNP 11 Roller with Cover / 4094 GNP 11 Roller Machine

Shown:

4092 GNP 7 Roller with Cover

Summary of content (4 pages)

PAGE 1
Hot Dog Roller Cover Assembly Manual Shown: 4092 GNP 7 Roller with Cover 4089 GNP Hotdog 5 Roller Cover For use with 4091 GAP 5 Roller with Cover / 4090 GAP 5 Roller 4088 GNP Hotdog 7 Roller Cover For use with 4092 GNP 7 Roller with Cover / 4078 GNP Hotdog 7 Roll Machine 4087 GNP Hotdog 9 Roll Cover For use with 4093 GNP 9 Roller with Cover / 4079 GNP Hotdog 9 Roll Machine 4104 GNP 11 Roller Cover For use with 4106 GNP 11 Roller with Cover / 4094 GNP 11 Roller Machine Copyright © 2012 DTX International
PAGE 2
Hot Dog Roller Cover Assembly Please review the parts list above and ensure that you have all the parts necessary to complete assembly. Should you have any difficulty assembling your cover or mating it to your Great Northern Popcorn Company Hot Dog Roller, please call our customer service line at (800) 665-0728, or email us at sales@greatnorthernpopcorn.com.
PAGE 3
Hot Dog Roller Cover Assembly (Cont.) 1) Remove the four screws, two on each side, from the top inner area of the hot dog roller. See figure 1. Figure 1 2) Place the back side glass mount (C) onto the machine and reinsert the screw. Do not tighten down the screw at this time because we may need to move it forward of back in a later step. See figure 2. Figure 2 3) Repeat step two for the other side rear glass mount (F) and the two front glass mounts(D&G). Remember not to tighten down the screws just yet.
PAGE 4
Hot Dog Roller Cover Assembly (Cont.) 5) Slide the curved top glass (B) into the rear side glass mounts and push all the way down. See figure 5. Ensure the edge of the curved top glass and the edge of the side glass are flush. See figure 6. Figure 5 If the glass seems too snug you may need to loosen one of the screws holding the rear side glass mounts. Once the top glass is in place, tighten the screw back down again.