User Manual

❏

1. Remove the brass wheel collar from the RimFire .10 motor.

❏

2. Install the RimFire .10 motor using the four 3

9mm

machine screws and 3mm ﬂ at washers. Before installing each

screw, apply a drop of threadlocker to the threads of the screw.

Make sure the motor is centered on the plywood motor mount.

❏

3. Connect the ESC to the motor. The ESC can be attached

to the side of the fuselage with adhesive backed hook and

loop material.

❏

4. Use adhesive backed hook and loop material to mount

the receiver to the side of the fuselage. Tape the two antennas

to the sides of fuselage. If using a 72 MHz receiver, route the

antenna out the cooling exit holes and tape it to the bottom

of the fuselage.

INSTALL THE RADIO SYSTEM

Install the Elevator Servo

❏

1. Insert one of the long 1 mm wire pushrods in the left

pushrod tube so that the Z-bend is at the aft end of the fuselage.

❏

2. Use a sharp hobby knife to remove the backplate from

the large nylon control horn. Insert the elevator pushrod

wire in the outer most hole of the control horn.