User Manual

❏

6. Apply a drop of threadlocker to the threads of four cap

screws. Thread the cap screws into four wheel collars. Slide

the wheel collars over the aileron pushrods. Insert the two 1 ×

25 mm pushrods 4mm from the center of the servo arm. Slide

the wheel collars over the 1 × 25 mm pushrods.

❏

7. Center the aileron servo arm and the ailerons. Tighten the

cap screws against the pushrods at the end of the pushrods.

FIN ISH THE MODEL

Install the Battery Straps

❏

1. Insert the piece of hook material in one of the slots of

the battery tray. Insert the loop material in the opposite slot.

Press the hook and loop material together under the battery

tray to make a battery strap.

❏

2. Cut and attach several pieces of the included adhesive

backed hook or loop material to the top of the battery tray.

Attach the opposite piece of the hook and loop material to

the back of your ﬂ ight battery.

Install the Canopy

❏

1. For our model we used the head from the Williams

Brothers 1/6 Scale Sportsman Pilot #18400 [WBRQ1140].

The pilot head had to be trimmed just under the nose to ﬁ t

under the canopy.

❏

2. Clean the cockpit surface with denatured alcohol

and a clean paper towel. Glue the pilot head in the cockpit,

approximately 3" [76mm] from the back of the cockpit.