Instruction Manual

Figure K
J
L
K
N
CD
I
H
Step 18: Place the 044 I and 048 H clamps onto the coupler and then place onto the throttle body.
Do not tighten at this time
Step 19: Slide the plastic bag over the GReddy intake tube so that you don’t scratch it. Once it is aligned,
you can pull the plastic off
Step 20: Install the tube inside the opening where your stock resonator ran through to the top of the air
box (You will install the tube from the bottom of the vehicle and guide it to the throttle body)
Step 21: Align the tube with the coupler and the isolation mount. Once aligned, tighten the clamps on
the coupler and use the washer L and nut N to tighten the bracket to the isolation mount
Refer to Figure K for step 18-21
Page 14