Instruction Manual

Refer to Figures K & L for steps 22-26
Step 22: Connect the vacuum hose C from the GReddy tube to the crank case. Use the clamp J to
tighten on the intake side
Step 23: Connect the vacuum hose D from the GReddy tube to the vacuum port. Use the clamp K to
tighten on the intake side
Step 24: Install the pre-filter onto the filter.
Step 25: Install the filter onto the GReddy tube. Do not push the filter too far onto the tube.
Step 26: Re-install the battery tray, battery, and reconnect your MAF sensor. Make sure everything is
tightened.
Figure L
GReddy.com
Page 15