Instructions / Assembly

Reverse the handle so it attaches
outside the lid of the grill. Make sure
the thermal isolation washers go
between the metal trim ring and the
lid on the outside, and between the
washer and lid on the inside.
Heat Shield: The slots go in the
front and rear to match the metal
strips inside the grill which hold it
in place. See Quick Start Guide
for proper alignment.
Always use two people, one on
each end, to fold open or close
the legs. This is not a one-person
job. If you plan to leave the grill
more or less permanently placed
on a table, then you might find it
more convenient just to remove
the legs.
Hang the grease pail on the right
side of the grill.
Bolt the chimney into position.
Make sure the rain cap is
always wide open when
cooking.
Grates:
Insert the grates as pictured.
IMPORTANT
Grease tray: Install the grease
tray with the half-moon cutout to
the left.
Important: Pour the contents of the
Ziploc bag into the firebox before you
install the rest of the parts. This is part
of the initial starting procedure.
Important:
Make sure to fill the hopper with
pellets as well before starting
your grill.
REVERSE THE HANDLE
INSERT THE PARTS
HALF MOON
LEFT SIDE
Recommended Installation:
Approx. 4” from the inside left
wall.
INSTALL THE LEGS
INSTALL THE CHIMNEY
53 54
Assembly - DC
Davy Crockett Assembly