Use and Care Manual

10.5 REPLACE THE SPOOL

NOTE

If any parts of the spool retainer assembly are damaged or

worn, replace the damaged part and reassemble them as

following showing

1. Disassemble the trimmer head . Pull and remove the

spool cover (b).

2. Clean dirt and debris from all parts. Replace spool (d) if it

is worn or damaged.

3. Loosen the screws (e). Remove the spool (d), slot covert

(f), location housing (g) from the spool assembly.

4. Replace with a new spool.

5. Insert the location housing and slot covert onto the spool

cover (b), and then put the spool onto the slot covert to

the disired position.

6. Tigthen with the screws.

10.6 REMOVE THE TRIMMER HEAD

1. Put the metal rod (a) in the specified angle transmission

hole (b) to fix the trimmer head.

2. Turn the trimmer head clockwise to loosen it. Do not

remove the spacer from the shaft.

10.7 ASSEMBLE THE TRIMMER HEAD

1. Put the metal rod in the specified angle transmission hole

to fix the trimmer head.

2. Assemble the trimmer head.

3. Turn the trimmer head counterclockwise to tighten it.

4. Remove the metal rod.

IMPORTANT

You must install the cut-off blade when you use the trimmer

head.

English