Use and Care Manual

13 TROUBLESHOOTING
Problem Possible Cause Solution
The machine does not start
when you push the trigger.
No electrical contact between the ma-
chine and the battery pack.
1. Remove battery pack.
2. Check contact and install the battery pack again.
The battery pack is depleted. Charge the battery pack.
The lock-out button and trigger are not
pushed at the same time.
1. Push the lock-out button and hold it.
2. Pull the trigger to start the machine.
The machine stops when
you cut.
The guard is not attached to the machine. Remove the battery pack and attach the guard to the
machine.
Heavy cutting line is used. Use only with the nylon cutting line of 0.095" / 0.080"
(2.4 mm / 2.0 mm) diameter.
The grass winds around the motor shaft
or the trimmer head.
1. Stop the machine.
2. Remove the battery pack.
3. Remove the grass from the motor shaft and trimmer
head.
The motor is overloaded. 1. Remove the trimmer head from the grass.
2. The motor will recover to work as soon as the load is
removed.
3. When you cut, move the trimmer head in and out of
the grass to be cut and remove no more than 8" in pass.
The battery pack or machine is too hot. 1. Cool the battery pack until its function returns to nor-
mal.
2. Cool the machine for approximately 10 minutes.
The battery pack is disconnected from
the tool.
Install the battery pack again.
The battery pack is depleted. Charge the battery pack.
The line does not advance. Not enough line on spool. Install more line.
Lines are worn too short. Advance the cutting line.
Lines are tangled on spool. 1. Remove the lines from the spool.
2. Wind the lines.
The line keeps breaking. The machine is used incorrectly. 1. Cut with the tip of the line, avoid stones, walls and
other hard objects.
2. Advance the cutting line regularly to keep full cut-
ting width.
The grass winds around
the trimmer head and mo-
tor housing.
Cut tall grass at ground level. 1. Cut tall grass from the top down.
2. Remove no more than 8" in each pass to prevent
wrapping.
The line does not cut well. The cut-off blade becomes dull. Sharpen the cut-off blade with a file or replace it.
14
English
EN