Owner's Manual

MAINTENANCE

REPLACING THE DRIVE BELT (See Figures 10)

• Ensure that the battery is not installed in the tool.

• Remove the 5 screws (1) that secure the left side plate (2) to the frame of the snow thrower.

Remove the side cover.

• Remove the old belt (3) from the small pulley (5) and large pulley (4).

• Loop one end of the new belt over the small pulley.

• Rotate the impeller with the left hand while positioning the belt on the large pulley with the

right hand.

• Install the left side cover, and secure it using the 5 screws that you previously removed.

Fig. 10